Dan!

Here be a picture of Dan with his head in his hand.

2014-04-25 16.53.50

This was done using a video of his head, broken out to frames.. etc etc .. and then an exacto-knife, and glue.  The head was rendered with 200 faces, and then further simplified (delete a bunch of complicated faces, fill holes).

Closeup:

image

I wish there was a way I could print this on plastic that would shrink about 5%, so that I could put a texture around a 3D print of the same thing.

Leave a Reply

Your email address will not be published. Required fields are marked *